To protect tungsten-halogen loads from fluctuating AC power levels, ETC dimmers normally regulate the output voltage to a specific level. No matter what type of dimmer you are using, you must set the dimmer to not regulate the sine wave on the circuit that is providing power to the Fixture. To best prevent accidental damage to fixtures, ETC recommends using relay modules or ThruPower modules to power LED fixtures. However, ETC will not cover under warranty any damage to the fixture caused by accidental dimming through improper configuration. If an ETC LED fixture fails while it is plugged into an ETC dimmer set to Switched mode, ETC will warrant the fixture in that case. ETC LED and Moving Light fixtures support being powered from an ETC Sensor or Unison dimmer module set to Switched mode. Often times we are asked if it is ok to plug a Moving Light or LED fixture into an ETC Sensor or Unison dimmer module.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |